How Loopz works
The Loopz is available in two variations: the Loopz Basic and the Loopz Plus.
The Loopz Plus has a built in UV-C light that further desinfects the water.
Loopz Basic
Water Reservoir
Shower Head
Sediment Filter
Micro Filter
Loopz Plus
Water Reservoir
Shower Head
Sediment Filter
Micro Filter
UVC-LED
The filtration module
Fill
Fill the reservoir until the light stops flashing. When there is not enough water in the reservoir, the LED gives a flashing signal. It is possible to fill the Loopz with warm water.
Reservoir
The water reservoir is located under the deck. When you turn on the shower, the filtration starts.
Sediment filter
This filter provides filtration of coarse dirt, such as grass and stones. This is done in two different ways. Firstly, the design of the tray creates flow patterns which causes larger particles to accumulate. In addition, the deck also contributes to the sediment filtration. It ensures that not all the dirt ends up in the water.
Microfilter
The microfilter consists of a stainless steel filter that filters small particles such as sand, hair and skin flakes. This filter is fine enough to filter out particles as small as 38 microns.
Pump
The operation of the pump speaks for itself. It pumps the water towards the optional UV-C light and then towards the shower hose.
UV-C light (Loopz Plus)
The UV-C light is optional and is only part of the Loopz Plus. The LED emits a certain wavelength that breaks down the molecular bonds of bacteria and viruses.
Shower
Finally, you can enjoy your shower! The filtered water from the shower head returns to the water reservoir and the cycle repeats itself.
After the shower, you can empty the water reservoir by using the drain. Make sure you don’t leave any harmful substances in the environment.
The filtered water does not have the same quality as drinking water. Substances that dissolve in water, such as soap, are almost impossible to filter.